Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

esx trunk ports

this is my standard trunk port config for my vms on the esxi servers

interface GigabitEthernet11/18

description trunk port on esx5 vmnic3

switchport

switchport trunk encapsulation dot1q

switchport mode trunk

switchport nonegotiate

no ip address

spanning-tree portfast

!

Do you see anything wrong or do I need to add anything else?

  • LAN Switching and Routing
1 REPLY
Cisco Employee

esx trunk ports

Hello,

Since this is a trunk use spanning-tree portfast trunk command instead of spanning-tree portfast. apart from this i dont think there is anything wrong with this configs. Do you see any problem in your setup?

Thanks,

Richard.

281
Views
0
Helpful
1
Replies