Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Eth and Serial port with RIP

In a situation of two router linked by the serial ports and the fastethernet

port of each router to each of their segment...

Router A Router B

A Segment <------> FastEth FastEth <------> B Segment

Serial <-------> Serial

To be able to send from A to B or vice versa

For Router A

#router rip

#network <IP>

!!!!!Here the <IP> is of which port....

For Router B

#router rip

#network <IP>

!!!!!Here the <IP> is of which port....

Thanks.

3 REPLIES
Hall of Fame Super Silver

Re: Eth and Serial port with RIP

Prakash

I do not fully understand your explanation of the topology and perhaps do not fully understand your question. But I believe that the answer you are looking for is that unless you are going to do something in RIP like redistribute connected, then there must be network statements under router rip that include both the interface(s) that rip will advertise over and also network statements that include the segments where end user stations are located that you want to advertise. So in your case it is the IP of both the serial and the etheret ports.

HTH

Rick

New Member

Re: Eth and Serial port with RIP

Router A Router B

A Segment <------> FastEth FastEth <------> B Segment

Serial <-------> Serial

New Member

Re: Eth and Serial port with RIP

Router A Router B

A Segment <--> FastEth ----- FastEth <-> B Segment

Serial <---- Serial

135
Views
0
Helpful
3
Replies
CreatePlease login to create content