Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ether Channel Between Cisco 4507R Switch and Non Cisco Firewall

Is it possible to do a Etherchannel Between Cisco 4507R Switch and Non Cisco (Juniper) Firewall, as Juniper Firewall has Aggregate Interface Option

Regards/Asfar

  • LAN Switching and Routing
4 REPLIES

Re: Ether Channel Between Cisco 4507R Switch and Non Cisco Firew

Yes its possible.As long as you use the IEEE standard on cisco switch.

New Member

Re: Ether Channel Between Cisco 4507R Switch and Non Cisco Firew

Use LACP channeling not PAgP which is Cisco proprietary.

Instead of "channel-group N mode on", use "channel-group N mode active" or channel-group N mode passive".

Andy

New Member

Re: Ether Channel Between Cisco 4507R Switch and Non Cisco Firew

Hi

Can you please check this config

interface range gigabitethernet 5/6 - 7

channel-group 2 mode active

end

!

interface gigabitethernet 5/6

switchport trunk encapsulation dot1q

switchport mode trunk

channel-group 2 mode active

!

interface gigabitethernet 5/7

switchport trunk encapsulation dot1q

switchport mode trunk

channel-group 2 mode active

Is that enough.

Regards

Cisco Employee

Re: Ether Channel Between Cisco 4507R Switch and Non Cisco Firew

That's fine. You should be good to go with this config. Make sure that you configure the juniper firewall ports as the L2 trunks also.

-amit singh

906
Views
0
Helpful
4
Replies
This widget could not be displayed.