Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Ether Channel result.

Hii Guys,

I have to configure Ether-Channel between two links with different banwidth capacity i.e 10 Mb and 18 Mb.

Guess it should work,but have bit confusion that what would happen if low bandwidth link i.e 10 Mb will utilised peak. Is there may be errors or isolation.

Second, If i make etherchannel with three links with capacity 10 Mb , 10 Mb and 8 Mb then what would be the result.

PLease share if anyone have some good documents on the same.

2 REPLIES
New Member

Re: Ether Channel result.

All elements of a port channel must be the same speed - I don't know how you would get an 18Meg ethernet connection anyway?

See document ref 12023

http://www.cisco.com/en/US/tech/tk389/tk213/technologies_tech_note09186a0080094714.shtml

Purple

Re: Ether Channel result.

What you are saying cannot be done as previously posted all links must be equal , 100 meg , gig etc...

95
Views
0
Helpful
2
Replies
CreatePlease to create content