Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Ether Channeling

I have a server that has two GB nics and have "teamed" them using HP teaming software. I would like to configure the switch to make thia a 2GB connection. How would I do this?

Mike

1 REPLY

Re: Ether Channeling

Hi,

What you should be checking with the HP Software is that if HP supports LACP or 802.1ad protocol for the Etherchanneling to the Cisco Switch.

If they do support the above mentioned protocol then you may take a bit of guidance from the below link otherwise, I would have had preferred to talk to the HP Support.

http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a008014edfa.shtml

Hope that helps,

Please rate if it helps,

Kind Regards,

Wilson Samuel

294
Views
0
Helpful
1
Replies