Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Etherchannel - 3750 Stack

Hi friends,

I attached the topology to better understanding.

Follow the scenario:

- I have two 3750 in stack, and two 3560;

- I configured the etherchannel in all devices:

3750 stack:

3750(config)#interface portchannel 1

3750(config-if)#switchport trunk encapsulation dot1q

3750(config)#interface range gigabitethernet 1/0/0-1/0/1

3750(config-if)#channel-group 1 mode on

3750(config-if)#switchport trunk encapsulation dot1q

3750(config-if)#switchport mode trunk

3750(config)#interface range gigabitethernet 2/0/0-2/0/1

3750(config-if)#channel-group 1 mode on

3750(config-if)#switchport trunk encapsulation dot1q

3750(config-if)#switchport mode trunk

two 3560 :

3560(config)#interface portchannel 1

3560(config-if)#switchport trunk encapsulation dot1q

3560(config)#interface range gigabitethernet 0/0-/0/1

3560(config-if)#channel-group 1 mode on

3560(config-if)#switchport trunk encapsulation dot1q

3560(config-if)#switchport mode trunk

After configured, works about 3 minutes, and the ports on the 3750 stack are disabled . What could be, the IOS version?

2 REPLIES
Purple

Re: Etherchannel - 3750 Stack

  Why do you have 4 ports configured on the 3750 and only 2 on the 3560's.?  Check the logs it will tell you a lot of the time why the channel was taken down.

Hall of Fame Super Gold

Etherchannel - 3750 Stack

Do a "sh log" and it will tell you WHY the channel went down.

Looking at your post above your etherchannel config is tupsy-turvey.  Put the physical interface into the channel-group FIRST. 

266
Views
0
Helpful
2
Replies