Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Etherchannel and Spanning tree

I am using bundling 4 switchport to connect a 4507 to a 3750 for layer2 connectivity.

int g1/0/1 - 4

switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode on

Should I configure spanning-tree on these ports or the port-channel interface?

If so, what spanning-tree should I use?

Thanks

1 REPLY
Hall of Fame Super Silver

Re: Etherchannel and Spanning tree

Hello Thom,

STP handles a bundle as a single link so if you need to tune STP configuration you can do it in port-channel interface mode

you don't need to change STP mode only for this reason.

Hope to help

Giuseppe

230
Views
0
Helpful
1
Replies