1)Based on the above result, it appears to me sw1 does shift the load from failed link to other active links in etherchannel. Is it true or Is it some bug in IOS? ( keep in mind the etherchannel in our case is staticallly configured using channel-group 1 mode on)
2) If you look at the output below
First packet no response
second packet response
third packet no response
fouth packet response
fifth packet no response
I do not understand why we are getting response for some pings packets and no response for others?
I guess here IOS and the device model plays the major roles in the etherchannels. Because when i looked at your post i have simulated in a cisco packet tracer as well as in my lab setup where i have 4560 Sup 2+ and 3750-12G switch.
When i tried with the packet tracer..... i found the dfficulties as such whatever you have observed. actually more than that.
But in my LAB when i did the same thing with 4506 and 3750 i couldn't find any issues. when we have the 1 link goes down there is a drop for a moment and after that everything looks well.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...