11-21-2006 04:10 AM - edited 03-05-2019 12:56 PM
Is it possible to create an EtherChannel connection between a 3750 stack (2 members) and the onboard LAN interfaces in a 2811?
If yes, could you point me to some doc / configuration examples?
Solved! Go to Solution.
11-27-2006 04:20 AM
My original question was "will this setup work with 3750 and 2811?"
I was hoping to end up with a configuration similar to the following;
http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a0080094958.shtml
I was hoping it wasn't limited to the 7200 & 7500 class of routers.
11-27-2006 04:33 AM
Hi KEITH,
Just got the answer on this for you.
Ether-channel is not supported on 2800 routers on the builtin FE ports. Its only supported on the etherswitch modules and the network modules on the routers.
Here is a bug for the same:
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCin55942
HTH, Please rate if it does.
-amit singh
11-27-2006 04:44 AM
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide