Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel Catalyst 4006 and stacking 3750

Hello,

i tryed to configure a etherchannel between a Catalyst 4006 CATOS 7.3 and a 2-stacked 3750 switch. I used 2 GB FX Ports.

I uses LACP with mode actice.

The ports did not build the channel.

Can there be a general problem with this hardware/software combination ?

Thanks

Peter

3 REPLIES
Purple

Re: Etherchannel Catalyst 4006 and stacking 3750

I am not sure catos version 7.3 supported LACP I would verify that first. If not use use PAGP instead .

Cisco Employee

Re: Etherchannel Catalyst 4006 and stacking 3750

CatOS 7.3 supports Lacp mode for ether-channels. Please see the config guide for the same.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4000/7.3/configuration/guide/channel.html#wp1032149

You have to make sure that your port configs on all the ports in an etherchannel has to be same. Configs regarding speed/duplex,STP,trunking feature all have to be exactly same on all the ports.

HTH,Please rate if it does.

-amit singh

New Member

Re: Etherchannel Catalyst 4006 and stacking 3750

Hello,

i forgot to mention that i was using cross stack Etherchannel. I think the problem is that the C 4006 is using PSTP and the C3750 is configured with STP.

Can this be the issue ?

Peter

212
Views
4
Helpful
3
Replies
CreatePlease login to create content