Etherchannel config

[ltrasmundi]

I keep getting the following message when I bring up the 2nd trunk. It works with only the one trunk up. Does anyone know why i am getting this message. It only works with one trunk up, does not matter which one. As soon as I bring up the 2nd trunk I get the following message.

1d01h: %EC-5-DONTBNDL: Gi3/2 suspended: incompatible partner port with GigabitEt

hernet3/1

1d01h: %EC-5-DONTBNDL: Gi3/2 suspended: incompatible partner port with GigabitEt

hernet3/1

[glen.grant]

You would have to post the config , you something configured wrong . Each side must have the exact same parameters . Is this a straight etherchannel or is it trunked also ? Are you bringing up both ports at the same time . Maybe if you post we can see it.

[aijaz802]

Hi,

The two ports in an ether channel should be identical in speed/duplex settings. if its a layer 2 trunk, then the allowed vlans should be same.

Please check again and rate this if it helps...

Thanks..

*aijaz*