Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel config

I keep getting the following message when I bring up the 2nd trunk. It works with only the one trunk up. Does anyone know why i am getting this message. It only works with one trunk up, does not matter which one. As soon as I bring up the 2nd trunk I get the following message.

1d01h: %EC-5-DONTBNDL: Gi3/2 suspended: incompatible partner port with GigabitEt

hernet3/1

1d01h: %EC-5-DONTBNDL: Gi3/2 suspended: incompatible partner port with GigabitEt

hernet3/1

2 REPLIES
Purple

Re: Etherchannel config

You would have to post the config , you something configured wrong . Each side must have the exact same parameters . Is this a straight etherchannel or is it trunked also ? Are you bringing up both ports at the same time . Maybe if you post we can see it.

Bronze

Re: Etherchannel config

Hi,

The two ports in an ether channel should be identical in speed/duplex settings. if its a layer 2 trunk, then the allowed vlans should be same.

Please check again and rate this if it helps...

Thanks..

*aijaz*

365
Views
0
Helpful
2
Replies
CreatePlease to create content