Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

etherchannel configuration between cisco and nortel

hi,

i am trying to configure etherchannel between cisco 6509 and nortel 8600 switch. but soon after configuring the port channel interfaces are going in error disable state. could anyone send the configuration for creating L2 etherchannel between cisco and nortel switches.

Thanks & Regards

Rajeev

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: etherchannel configuration between cisco and nortel

hello rajeev,

Nortel uses MLT for etherchannel configs.

have a look at page 329 of the attached doc.

HTH

5 REPLIES
New Member

Re: etherchannel configuration between cisco and nortel

hello rajeev,

Nortel uses MLT for etherchannel configs.

have a look at page 329 of the attached doc.

HTH

New Member

Re: etherchannel configuration between cisco and nortel

Thanks...

Rajeev

New Member

Re: etherchannel configuration between cisco and nortel

Description: Multicast problem:

Topology :Remote site->MPLS cloud->switch1 3750->ASA 5510-> LAN switch 3560E

Switch1 inside interface(int vlan) which is connected to ASA is configured with IP PIM passive.

Q: Will my multicast work on LAN and able to receive multicast traffic from remote site?

Silver

Re: etherchannel configuration between cisco and nortel

you'll need multicast VPN inside the MPLS cloud. Ask your ISP if they have it - they should.

New Member

Re: etherchannel configuration between cisco and nortel

Thanks for your comment...

yes they have VPN in cloud, customer says some time multicast work sometime doesn't. Tac has suggested to upgarade the image of LAN switch as the existing image only support IP PIM PASSIVE command on edge switch. But customer says why it works somtime and othertime stops working...

1179
Views
3
Helpful
5
Replies
CreatePlease to create content