Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

EtherChannel Configuration in L2

Hi,

I m trying to configure trunk ports between my L2 switches in etherchannel configuration

I have tried to use them in desirable and in auto mode

Considering the attached network diagram , the top most switch is NTP server rest all are its clients , Router is configured with subinterfaces

Now when i try to ping from the desktop keeping port channel as desirable i get replies sometimes but very high latency

in auto mode i dont get replies at all

Config

Interface range fa 0/1-2

swithport mode trunk

channel-group 2 mode desirable

what m i missing ?

wht is the significane of group name in these ??

1 REPLY
VIP Super Bronze

EtherChannel Configuration in L2

Hi,

Try using mode on and test again.

Interface range fa 0/1-2

swithport mode trunk

channel-group 2 mode on

HTH

160
Views
0
Helpful
1
Replies
CreatePlease to create content