Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Etherchannel configuration

I just purchased 3 2960S-48FPD-L switches. I also ordered one (soon to be 2) 3850-24t-L. I am currently looking at purchasing an NM 4-1G module to go with the 3850. My intent in this is to configure etherchannels from the 3- 2960's front SFP ports, to the 4 port module I am getting for the 3850. I just want to make sure it is possible?

Thanks,

Wayne

2 REPLIES
Bronze

yes it is possible. regardsrc

yes it is possible.

 

regards

rc
 

Silver

Hi,   As long as the SFP you

Hi,

 

 

 As long as the SFP you are going to use on both ends you should be fine, therefore just make sure of that.

 

Regards,

42
Views
0
Helpful
2
Replies