Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel help

Hi,

We have 2 C3750 switches trunked together using an Etherchannel (2 trunk links). In the config it doesn't show what type of load-balnce we are using eg scr-mac scr-ip? How can I find this out?

2 REPLIES
Bronze

Re: Etherchannel help

Hello,

Simply type 'show etherchannel load-balance'

It is set to source-mac by default.

Re: Etherchannel help

the default always src-mac

you can change it useing the following command:

Switch(config)#port-channel load-balance ?

dst-ip Dst IP Addr

dst-mac Dst Mac Addr

src-dst-ip Src XOR Dst IP Addr

src-dst-mac Src XOR Dst Mac Addr

src-ip Src IP Addr

src-mac Src Mac Addr

good luck

if helps Rate

119
Views
0
Helpful
2
Replies
CreatePlease login to create content