Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel issue with netapp

Hi

I have an etherchannel configured on a cat6k to connect to a netapp. the ints in the channel group are up but the port channel is down. when i do a show etherchannel summary it show that the ports are in portchannel 12A not 12. Any ideas

the config is attached.

3 REPLIES
Green

Re: Etherchannel issue with netapp

Hi,

Looking at this link seems to infer that there is some difference between the 2 physical ports.

http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a0080094470.shtml#po1a

I do not see what is is.

May be show interface might point to the issue

A second prt channel xxA is created by lacp when discrepencies are found in the original xx channel group

Regards

Alex

Regards, Alex. Please rate useful posts.

Etherchannel issue with netapp

In addition check the version of the netapp device - Last week I had similar issues with a netapp device. The solution was a software upgrade on the netapp-filer.

regards

Marcel

New Member

Etherchannel issue with netapp

Can you paste an ifconfig -a output from the netapp controller here?

784
Views
0
Helpful
3
Replies
CreatePlease to create content