Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Etherchannel mode on question

Hello all,

I'm trying to setup etherchannel between two layer2 swtich in Cisco Packet Tacker, two switch fa0/1 and fa0/2 for etherchannel with trunk (mode on), and fa0/3 connected PC with access vlan 10.

But show etherchannel port both ports is down, can someone help ?

  • LAN Switching and Routing
3 REPLIES
Cisco Employee

Can you send what you

Can you send what you configured?

Cisco Employee

It should be a pretty simple

It should be a pretty simple task, just do "channel-group x mode on" on both sides, make sure physical and logical interfaces are "no shut" 

New Member

The sample config per port

The sample config per port shud b like this:

interface fa0/1

switchport mode trunk

switchport trunk allowed vlan 10

channel-group 1 mode on

Once u do it on per port per switch it will automatically create port channel 1 (since channel-group is 1 here) on both the switches.

Regards.

 

149
Views
0
Helpful
3
Replies
This widget could not be displayed.