Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Etherchannel on 1841 with a HWIC-4ESW card

Hi,

We're trying to group two ports together on the 1841 router which has a HWIC-4ESW 4-port 10/100 BaseT Ethernet Switch HWIC.

I have tried:

------------------------

interface Port-channel1

description ???????

switchport trunk encapsulation dot1switchport mode trunk

no ip address

channel1

interface fastethernett0/1

switchport trunk encapsulation dot1q

switchport mode trunk

no ip address

channel-group 1 mode on

------------------------

However it does not seem to accept creating the interface channel. Any help would be appreciated.

Thank you.

1 REPLY
Silver

Re: Etherchannel on 1841 with a HWIC-4ESW card

Hi,

I'm afraid this module does not port aggregation.

Please refer to this link for the features:

http://www.cisco.com/en/US/products/ps5853/products_data_sheet0900aecd8016bf0b.html

Hope it helps, rate if does

Krisztian

1329
Views
0
Helpful
1
Replies
CreatePlease to create content