Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Etherchannel on 3560 switch to Broadcom Gigabit Cards

I was wondering if anyone has setup a Server with Broadcom NIC for Etherchannel. What method of Load balanacing did you use? Did you have to configure the switch

1 REPLY

Re: Etherchannel on 3560 switch to Broadcom Gigabit Cards

You have to use LACP between the server NIC's and the 3560 switch ports. Make sure that you server NIC driver support the port-bundeling and also have the load-balancing mechanism. Please find the link below on configuring switchports for ether-channel using the LACP :

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3560/12225sed/scg/swethchl.htm

HTH,Please rate if it does.

-amit singh

666
Views
4
Helpful
1
Replies