Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel suspend

Hi

I have 2 interface bundled in channel if one of interface change state to suspend (speed and duplex mismatch) but the remain interface still up and in channel why all traffic can't pass on remain interface in channel ( ex.I can't ping neighbor switch )

thanks

1 REPLY
Bronze

Re: Etherchannel suspend

Hi,

Pls. check whether the port channel is up on both ends. check the trunk and allowed vlans(if any) configuration.

Are u able to ping with only one interface in ether channel either side?

If one of the interface is down then also the port channel should work, thats why port channel also used for the redundancy. Please re-check the channel configuration.

Rate if it helps.

Regards,

*aijaz*

362
Views
0
Helpful
1
Replies
CreatePlease to create content