Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Etherchannel Using 10 Gig Ethernet

Hi All,

Because of problems with 10gig trunks using another vendors hardware, the company have decided to replace our hardware with 6509.

As I will be supporting the new cisco hardware, i was just wondering if there are any known issues with 10 gig trunks.

Any information appreciated, config ,troubleshooting etc. Can the cabling in the trunk be either copper or fibre.

1 REPLY
Hall of Fame Super Silver

Re: Etherchannel Using 10 Gig Ethernet

Hello Harry,

first of all you need a sup720 supervisor to support 6708 or 6716 linecards

bundling of tengiga ports is possible also using LACP.

About media type see the link

http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6974.html

see table 6 of above documents for HW and SW requirements

Hope to help

Giuseppe

370
Views
0
Helpful
1
Replies
CreatePlease to create content