Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel using Cisco 2960G with Cisco 3750

Hi,

I have a core switch Cisco 3750G (1 No) and Cisco 2960G (7 Nos).I have successfully created " Etherchannel between Cisco 2960 G (6 Nos) to Core Cisco 3750,when I am trying to configure the ether channel between the 7th Cisco 2960 G to the core cisco 3750,it is not allowing me to....As the Cisco document the Cisco 2960 G will support upto 6 etherchannel.Is there any way to configure nore than 6 ether channel.Please guide us.

Regards,

Lavanholy

1 REPLY

Re: Etherchannel using Cisco 2960G with Cisco 3750

NO of etherchannel is limited to 48 on 3750 as per IOS 12.2(25)SEE

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_25_see/configuration/guide/swethchl.html

For 2960G it is limited to 6 as per IOS 12.2(25)SEE.

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_25_see/configuration/guide/swethchl.html#wp1275881

Best option would be to have 2 cores, and put one uplink from 2960G to each 3750 without etherchannel.

So you have core redundancy at 3750.

And you have uplink redundancy at 2960G.

331
Views
0
Helpful
1
Replies