Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EtherChannel works when 3750G stack master fails?

Hi All,

I try to combine two uplinks from two 3750G stack switches into one etherchannel connected to another two stack switches which has one etherchannel too. If the master switch fail, then one link in the etherchannel goes down. I think the etherchannel should have no outage with this master failure, right?

Thanks a lot for the help!

Lou

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: EtherChannel works when 3750G stack master fails?

Hello,

3750 platform supports cross-stack etherchannel. In other words, the whole

stack is treated as one switch. So, if the master goes down, only ports on

the master go down and the etherchannel stays up. The slave inherits all the

masters configurations and continues to operate normally.

Hope this helps.

Regards,

NT

1 REPLY
Cisco Employee

Re: EtherChannel works when 3750G stack master fails?

Hello,

3750 platform supports cross-stack etherchannel. In other words, the whole

stack is treated as one switch. So, if the master goes down, only ports on

the master go down and the etherchannel stays up. The slave inherits all the

masters configurations and continues to operate normally.

Hope this helps.

Regards,

NT

527
Views
0
Helpful
1
Replies