Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel

Hi everybody,

is it possible to have a layer 3 Etherchannel up and running if I use FastEthernet on one side and GigabitEthernet on the other side?

Regards

Stefano

3 REPLIES
New Member

Re: Etherchannel

I never did that. But why would you use 100mbit and 1000mbit together in etherchannel? Why not rather use 100mbit on the other switch too?

In any case, link would be 100mbit.

Or you can use uplink ports - they are usually 1000mbit.

Which switches are you talking about?

New Member

Re: Etherchannel

I have a Cisco 3825 router on one side and a Catalyst 3750G-24TS on the other side. The GigabitEthernet on board interfaces on 3825 are busy so I have to use FastEthernet on NM-2FE2W_V2.

Regards

Stefano

New Member

Re: Etherchannel

Well, altough I never did eth.channel between 100 and 1000 I believe it would work.

In "worst case" you would need to set speed to 100 manually on 3750 switch.

Interface ge0/x - speed 100

And thats it.

Try, and report ;-)

112
Views
3
Helpful
3
Replies
CreatePlease login to create content