Can someone tell how to resolve the problem as i have given .. I have two 3560 Switches connected with each other by configuring etherchannel on port fa 23,24 port same on both. But i am getting error, while it had completle to configure.
%EC-5-CANNOT_BUNDLE2: Fa0/24 is not compatible with Po1 and will be suspended (vlan mask is different)
Thanks for asking before i just found mismatch in my configuration.I have found that this error displayed, when the vlans assigned to port-channel and interfaces were not same, it did not retrieve correctly, appling this change I got my interfaces in a group, as it is better to know that etherchannel required same configuration on all interfaces..
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...