Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ethernet L3 subinterface load

Hello!

The Costumer branches are connected to the central router via MPLS.

The central router has Fastethernet interface and one-one subinterface ( dot1q ) to every branches.

Unofrtunetly the IOS shows the main interface load only.

How can we know the subinterface loads???

We don't know check the loading of the branch lines.

Regards,

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ethernet L3 subinterface load

There is no way in IOS to check subinterface load Afaik.

7 REPLIES
Cisco Employee

Re: ethernet L3 subinterface load

Hi,

What about checking the load of the WAN interface of the branch router ?

HTH

Laurent.

New Member

Re: ethernet L3 subinterface load

Hi!

There are dot1q trunk also ( QinQ )

Regards,

Cisco Employee

Re: ethernet L3 subinterface load

There is no way in IOS to check subinterface load Afaik.

New Member

Re: ethernet L3 subinterface load

The cisco should plan this feature in the next releases.

Regards

Hall of Fame Super Silver

Re: ethernet L3 subinterface load

Hello Karoly,

to check traffic on Vlan based subinterfaces you can use:

sh vlan

or

sh vlans

(ios version dependent)

see this example

sh vlan

Virtual LAN ID: 1 (IEEE 802.1Q Encapsulation)

vLAN Trunk Interfaces: FastEthernet0/0.1

FastEthernet0/1

This is configured as native Vlan for the following interface(s) :

FastEthernet0/0

FastEthernet0/1

Protocols Configured: Address: Received: Transmitted:

IP 10.48.128.2 2360279291 3961759836

IP 10.97.148.6 2360279291 3961759836

CLNS 14053144 0

Virtual LAN ID: 4 (IEEE 802.1Q Encapsulation)

vLAN Trunk Interface: FastEthernet0/0.4

Protocols Configured: Address: Received: Transmitted:

IP 10.97.132.2 76334376 72987461

Virtual LAN ID: 5 (IEEE 802.1Q Encapsulation)

vLAN Trunk Interface: FastEthernet0/0.5

Protocols Configured: Address: Received: Transmitted:

IP 10.97.144.2 7228026 7206777

by using this command over time you can have an idea of traffic load for every vlan subinterface.

Unfortunately these are only packet counters.

Hope to help

Giuseppe

New Member

Re: ethernet L3 subinterface load

Hi,

very thnks.

It's a very interesting command.

it is a nearly perfect solution :-)

Regards,

New Member

Re: ethernet L3 subinterface load

Hi!

I've found the next very interesting solution.

The PRTG traffic grapher maps the subinterfaces and draws correct graphs. (kb/s)

therefore somewhere in the IOS there are the subinterrfaces counters and we can read them via SNMP!!??

262
Views
0
Helpful
7
Replies