Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Explanation of mroute flags?

Would someone point me to a white sheet, or section of a config guide, that would explain all the flags in the 'sh ip mroute' display? I looking for something more enlightening than just a discription of the flag; ie. "'The SPT-bit set' means the Shortest Path Tree bit is set," but actually explain what causes the flags, and caveats if some flags are set and others aren't.

NGT-SW3750-CD-MDF#sh ip mroute

IP Multicast Routing Table

Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,

L - Local, P - Pruned, R - RP-bit set, F - Register flag,

T - SPT-bit set, J - Join SPT, M - MSDP created entry,

X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,

U - URD, I - Received Source Specific Host Report, Z - Multicast Tunnel

Y - Joined MDT-data group, y - Sending to MDT-data group

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Explanation of mroute flags?

This is the best I have.

Enjoy

3 REPLIES
Bronze

Re: Explanation of mroute flags?

Well, here is the official command reference for "show ip mroute" command:

http://www.cisco.com/en/US/docs/ios/12_2/switch/command/reference/xrfscmd6.html#wp1056899

Now if your like me - that still doesn't tell you "jack" about why such and such would be shown. I personally refer to a multicast book by Beau Williamson ("Developing IP Multicast Networks") which gives better detail about those flags. I can say that book is considered the "bible" on multicasting and will probably answer almost all your questions.

I hope that helps.

Jim

Community Member

Re: Explanation of mroute flags?

Thanks for the tip on the book - looks like something I should purchase.

Silver

Re: Explanation of mroute flags?

This is the best I have.

Enjoy

587
Views
15
Helpful
3
Replies
CreatePlease to create content