Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Extended vlans on 6509 sup1a

My telco assigned me an etxented vlan for a metro ethernet deployment. I have no option but to use extended vlans. My routers and remote site hardware have been upgraded and can process extended vlans. My problem is with my sup1a in my central site. My software on the sup1a is 6.4(21). If anyone can offer any suggestions on configuring extended vlans on the sup1a it would be greatly appreciated. Thanks in advance.

1 REPLY

Re: Extended vlans on 6509 sup1a

To create extended-range VLANs, you must first enable MAC address reduction, which provides IDs for extended-range VLANs. After you enable MAC address reduction, you cannot disable it as long as any extended-range VLANs exist.

To enable MAC address reduction and create an Ethernet VLAN in the extended range, perform this task in privileged mode:

Step 1 - Enable MAC address reduction. - set spantree macreduction {enable | disable}

Step 2 - Create a VLAN. - set vlan [vlan]

Step 3 - Verify the VLAN configuration. - show vlan [vlan]

Console> (enable) set spantree macreduction enable

MAC address reduction enabled

Console> (enable) set vlan 2000

Vlan 2000 configuration successful

Console> (enable) show vlan 2000

VLAN Name Status IfIndex Mod/Ports, Vlans

---- -------------------------------- --------- ------- ------------------------

2000 VLAN2000 active 61

VLAN Type SAID MTU Parent RingNo BrdgNo Stp BrdgMode Trans1 Trans2

---- ----- ---------- ----- ------ ------ ------ ---- -------- ------ ------

2000 enet 102000 1500 - - - - - 0 0

VLAN Inst DynCreated RSPAN

---- ---- ---------- --------

2000 - static disabled

VLAN AREHops STEHops Backup CRF 1q VLAN

---- ------- ------- ---------- -------

Console> (enable)

Hope this helps

Martin

190
Views
0
Helpful
1
Replies