I have a requirement to connect two sites with T3 circuit using 3845 with NM-1T3 serial module. The 1st site is primary site and 2nd site is remote site that is an extended switched network of pri site. Due to time constraints (or I would use TSL) I have to use T3.
I am trying to implement the quickest (easiest) T3 solution to connect sites. Each site has 3845 with T3 module and switched network behind. Pri site has DHCP server and rest, remote site will get all network config and dependent on pri site, VLANS need to be trunked from remote to Pri across T3.
Please let me know the solution, example config between sites, or link for config.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...