Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

F5 Big-IP Cat 6509 connectivity problem

Hello,

we performed a software upgrade on the Big-IP.

After that the BIG-IP stopped working properly;

obviously the communication to the connected

Cat6509 was not working. tcpdump shows only

outgoing traffic, nothing incoming. The port

on the 6509 is connected and does not show up

any error.

Any idea? Every comment welcome!

Best regards, Snitram

4 REPLIES
Hall of Fame Super Bronze

Re: F5 Big-IP Cat 6509 connectivity problem

Perhaps the port is in err-disabled.

Try disabling/enabling the port from the CLI.

If running CatOS, try, 'set port disable mod/port' - then 'set port enable mod/port'

If running Native IOS, try

interface mod/port

shut

no shut

New Member

Re: F5 Big-IP Cat 6509 connectivity problem

No, the port is not err-dis. I even tried

to disable and enable. The result is always

that the port is connected, but connectivity

is broken (in tcpdump on the Big-IP I

see only outgoing packets, nothing incoming).

The counters on the 6509 are showing the

same.

Snitram

Hall of Fame Super Bronze

Re: F5 Big-IP Cat 6509 connectivity problem

If the problem resulted after upgrading the Big-IP, I suggest opening a ticket with them.

The other thing I may suggest is changing the layer1 connectivity to another switchport.

New Member

Re: F5 Big-IP Cat 6509 connectivity problem

I have been out of the BigIP Game for about a year. However from my experiance the BigIP and Cisco do not negotiate 10/100 Duplex settings well. I would verify that both the 6500 and the Big IP are locked at Speed 100 and Full Duplex. If you are using 1Gbps interfaces you should be able to use Auto/Auto for your negotiation but if that is your current setting try using speed 1000 Full duplex.

If changing the duplex then a shut/no shut sequence doesn't work then I would either roll back to your old BigIP Code or Open up a support case or both.

Good Luck.

www.staticnat.com

317
Views
0
Helpful
4
Replies