Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

FabricPAth L2/L3 boundary problem

Hi!

Router connected to N7k-Left which is a part of FP domain.

vl100 - FP vlan, configured HSRP,active is N7k-left.

when i ping addresses on n7k-left - it is ok,but failed if i ping n7k-right.

do i need direct link to N7-right?

why N7k-right(10.89.0.3) is not response via peer-link?

Mike 

asr1002x#ping 10.89.0.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.89.0.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms


asr1002x#ping 10.89.0.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.89.0.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms


asr1002x#ping 10.89.0.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.89.0.3, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
asr1002x-right-b2b-bor#

 

Everyone's tags (1)
111
Views
0
Helpful
0
Replies
CreatePlease to create content