Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Failed in state 0 - error when booting with dual Sup 2

Attempting to build a 6509 with Supervisor 2s in module 1 & 2 - OS is

CatOS 8.5.2.

When powered on with both sups in place, the system keeps repeating "Failed in stat 0" and will not start. We moved the modules to a 6506 and it booted properly.

The 6509 will boot with a single Supervisor 2 in module 1. We suspect a hardware issue with the chassis - is there anything we should check before opening a TAC case?

2 REPLIES

Re: Failed in state 0 - error when booting with dual Sup 2

What happens when you boot with one installed, allow it to load, then insert the second module.

If it stays up, issue the command :-

show module 2

to get some more details.

New Member

Re: Failed in state 0 - error when booting with dual Sup 2

We had tried that. The switch stayed up, but didn't see module 2 at all - not listed when we did "show module"

105
Views
0
Helpful
2
Replies