Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Failed mtu config

I am trying to increase the mtu on an etherchannel but I am getting an error saying that the gig interface does not support the mtu change. the connections are copper connections b/w 2 6506s.

TIA,

2 REPLIES
Bronze

Re: Failed mtu config

Gig interfaces on a PIX will fail to establish link to a peer that does not support auto-negotiation. This behavior is seen when the PIX interface is set to 1000auto, 1000basesx, and 1000sxfull.

New Member

Re: Failed mtu config

I resolved my issue. I am using the WS-X6548-GE-TX which does not support jumbo frames.

238
Views
0
Helpful
2
Replies