I have two Servers in different Networks and all the users need to access the server. When one server will be down the user's traffic will be forwarded to another servers. I need this solution in router level and with configuration of Nating. Please find the low level diagram.
As mentioned in the previous message, the only IOS feature that will perform this function is Server Load Balancing (SLB). This is only supported in a limited number of platforms and IOS versions (www.cisco.com/go/fn)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...