cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
310
Views
0
Helpful
2
Replies

Failover routing possibilities?

raza555
Level 3
Level 3

Hi,

Please see the scenario is attached diagram.

I want that when the connection between firwall and internet goes down, traffic seemlessly flow towards the CE and then via BGP to the other side SiteB

Also when the MPLS circuit goes down, traffic seemless flow toward firewall and then via site to site tunnel to the other side SiteB

How we can achieve this?

 

we have no access to the SiteA-Core router.

CE has default route to the SiteA-Core router.

 

solution1: shall we create a OSPF between the CE and the firewall and SLA monitor the interfaces towards SiteB, but I don't know how we can achieve this.

Any advise is much appreciated. If you can show the OSPF scripts for this failover, it will me very helpful

 

Thanks

2 Replies 2

chlupmichal
Level 1
Level 1

Hello rizwan.

So if I got you correctly, in case the both links (via FW and through CPE) are up, you want to load balance the traffic via both paths towards the site B?

Because you have mentioned only scenarios when one link fails, not which path should be selected in case both are up.

Regards,

Michal

Robert Falconer
Level 1
Level 1

Like Michal, I would like to know what your preferred traffic path is.

 

Also, what does your site B look like? 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco