Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FastEthernet interface keeps losing the trunk config

   So we have FA0/13 configured to use our Aerohive wirless. But for the past week its been losing the turnk config and I have no idea why. Heres the config we have in the 3550 switch for that interface. This interface is trunked to all of our VLANs

interface FastEthernet0/13

switchport access vlan 100

switchport trunk encapsulation dot1q

switchport trunk native vlan 100

switchport mode trunk

no ip address

spanning-tree portfast

Any ideas as to why it keeps dropping the config?

Thanks

1 REPLY
Hall of Fame Super Blue

Re: FastEthernet interface keeps losing the trunk config

Mike

I don't know why it is doing it (maybe a bug) but i would modify the config ie.

1) if it is a trunk remove the "switchport access .." line

2) if you are sure it cannot create a loop then you should change "spanning-tree portfast" to "spanning-tree portfast trunk".

If you are not sure then there should be no portfast command on that port.

Then see if this helps.

Jon

69
Views
0
Helpful
1
Replies
CreatePlease to create content