Your line protocol is down on the interface and hence the interface is still on its default mode auto/auto. Once the interface and line protocol are up/up, it should show you Speed 100 and duplex full.
If its up/down then it is usually a physical layer problem , it is not seeing anything from the other end . Try coding the port to auto and see if it will come up , if not a site visit is going to be in the works ...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.