12-21-2006 05:59 AM - edited 03-05-2019 01:27 PM
A high number of FCS and Alignment errors are reported on one switchport. The possible causes are:
A defective port
Bad cabling
duplex mismatch
wrong speed settings
subnet mismatch
Over subscription of the link
12-21-2006 06:02 AM
Hi Friend,
A defective port & Bad cabling can be the possible reasons for FCS and Alignment errors.
HTH
Ankur
*Pls rate helpfull post
12-21-2006 08:44 AM
Its usually speed/duplex mismatches check the settings for the switchport and whatever is attached on the far end , they must match .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide