I see that the fex interfaces supports "no switchport" command.. I dont see any document saying that it supports pure layer 3 ? We basically have the M148 module on a N7K, and want to replace it with a FEX 2232 connected to the same 7K (for freeing up this module and use M224 or F248 instead in that slot)...
As of today we have only a few connections on M148, but few of those are layer 3 1 Gig interfaces. Can I move them to 2232 and still have the same functionality when working with N7K?
I would look at this to see if it answers your question, http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus2000/sw/configuration/guide/rel_6_2/b_Cisco_Nexus_2000_Series_NX-OS_Fabric_Extender_Software_Configuration_Guide_Release_6-x/b_Configuring_the_Cisco_Nexus_2000_Series_Fabric_Extender_rel_6_2_chapter_010.html#reference_E9C2D0CE06DB4289A543623C3E60B76D
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...