Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Fiber optic Communication sudden loss on Catalyst WC-2960

Hi All,

Am newbie with FO communication with Cisco switches.

Am using Catalyst WC-2960 switch with FO patch panel to route fiber optic communication. It's working fine, but communication lost occurs randomly. If am trying to ping my devices on the other side, out of 50 pings , 5 are lost.

Please advise what to do?

Appreciate your quick response,

Regard,

Tariq Taha

Everyone's tags (1)
7 REPLIES
Hall of Fame Super Gold

Re: Fiber optic Communication sudden loss on Catalyst WC-2960

Can you post the interface config of your SFP?

Does the interface show  going down with the "show logs"?

New Member

Re: Fiber optic Communication sudden loss on Catalyst WC-2960

Hi leolaohoo ,

How to get the SFP interface config and the log?

I don't know how to connect to the switch diagnostics platform. I don't an IP of the switch and there is no serial port.

Regards,

Tariq

Re: Fiber optic Communication sudden loss on Catalyst WC-2960

Tariq,

Do you know how to console or telnet into the switch?

Mike

New Member

Re: Fiber optic Communication sudden loss on Catalyst WC-2960

Hi Mike,

Yeah i saw the console port... but it's not for normal ethernet cable isn't it...

i know about telnet...

what do i need to do ... to start a telnet session with the switch?

Tariq

VIP Super Bronze

Re: Fiber optic Communication sudden loss on Catalyst WC-2960

Tariq,

You need a management IP address on the box before you can telnet to it.  If you already have a management IP on it then just open up Secure CRT or putty or any other alike application you have and access the device

HTH

Reza

tariqtaha wrote:

Hi Mike,

Yeah i saw the console port... but it's not for normal ethernet cable isn't it...

i know about telnet...

what do i need to do ... to start a telnet session with the switch?

Tariq

New Member

Re: Fiber optic Communication sudden loss on Catalyst WC-2960

Hi Reza,

I don't have management IP on the switch, what i neeed to do to set it..

Thanks,

Tariq

VIP Super Bronze

Re: Fiber optic Communication sudden loss on Catalyst WC-2960

Tariq,

If there is no IP on the switch, then you need to login using the console port.  For this you need a console cable that comes in the box with all the switches and routers.  Once you login via console then you can add a management IP for future use for telnet access.

HTH

Reza

551
Views
5
Helpful
7
Replies