is it possible to filter say 7-8 different ip address by creating a group and apply that group acl. eg.
if i have 10.5.5.10,172.16.10.10,192.168.20.20,192.168.10.10 etc, rather than creat individual permit/deny acl can i not just group the above ip address and then apply the acl. so in future if these ip addresses change, i can just change it in one place.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.