Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
New Member

Find Power Supply Serial Number in a WS-C4006

C45SW001#show version

Cisco Internetwork Operating System Software

IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-IS-M), Version 12.1(8a)EW1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

TAC Support:

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Wed 20-Feb-02 18:02 by eaarmas

Image text-base: 0x00000000, data-base: 0x00AA30DC

ROM: 12.1(20r)EW1

C45SW001 uptime is 2 years, 18 weeks, 2 days, 3 hours, 39 minutes

System returned to ROM by reload

System restarted at 08:33:38 WET Sun Oct 29 2006

System image file is "bootflash:cat4000-is-mz.121-8a.EW1.bin"

cisco WS-C4006 (MPC8245) processor (revision 7) with 262144K bytes of memory.

Processor board ID FOX062500E5

Last reset from Reload

48 FastEthernet/IEEE 802.3 interface(s)

14 Gigabit Ethernet/IEEE 802.3 interface(s)

467K bytes of non-volatile configuration memory.

Configuration register is 0x2102

C45SW001#show idprom ?

all show all IDPROMs

chassis show IDPROM for chassis

module show IDPROM for module

supervisor show IDPROM for supervisor


Any ideias ?

Best Regards,

Bruno Petrónio


Re: Find Power Supply Serial Number in a WS-C4006

Normally you would use show idprom power-supply # . If its not there then its because your code is so out of date , only way then is to manually pull them and get the numbers off the power supplies, otherwise upgrade the code and the command will be there. Just used it to get power supplies replaced from cisco. Looking at your display it says 4006 , is this the chassis with 3 power supplies ? If so I don't think you can get that info from the command line with that chassis as that was normally used with catos supervisors and it wasn't available even on catos supervisors that i remember.

New Member

Re: Find Power Supply Serial Number in a WS-C4006

Tks Glen,

That's right, 3 PS slot's, and running IOS.

Thank you anyway.

Best Regards,


CreatePlease to create content