show ip int brief will tell you which IP address is configured internally on each VLAN and on each layer-3 "no switchport". However, it will not tell you anything about the IP addresses of devices connected to the layer-2 switchports, which is what I think the original posting was asking about.
show ip int brief is a very powerfull command and can show alot but keep in mind that it only shows primary ip adresses.
But Show mac-add interface fa0/1 shows the MAC addr. on the fysiscal interface and then you can do an show ip arp | include [the macaddr from former command] and then you have the ip addr. of the client on the specific interface...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.