05-05-2007 11:46 AM - edited 03-05-2019 03:53 PM
Here's the setup:
One 6509 with FWSM and its 5 security contexts. Hosts are directly connected to the 6509, but are routed through security contexts.
I have an IP address of one of the hosts off the router. The IP obviously wouldn't show up on the ARP table. I get the security context's outside IP when I do a sh ip route x.x.x.x.
So, how do I find out which port contains the host with this IP? Am I out of luck without having a MAC?
Thank you.
Solved! Go to Solution.
05-07-2007 07:34 AM
Hi Greg
Could you not just look at the arp table within the right FWSM context which would give you the mac-address which you could then track down on the 6500 chassis.
Have i misunderstood the issue ?
Jon
05-07-2007 07:34 AM
Hi Greg
Could you not just look at the arp table within the right FWSM context which would give you the mac-address which you could then track down on the 6500 chassis.
Have i misunderstood the issue ?
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide