Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

finding switch port

Hi, i have about 30 L2 switches in my LAN, every time Support team ask me to find where a particular PC is connected on LAN, switch ip and port connected to.

Is there a software in which i add my all switches ip address, and my support team just enter the ip address of machine they are finding, and it give output with switch ip and port number where that particular PC is connected/?

Thank you in advance.

7 REPLIES
Bronze

Re: finding switch port

CiscoWorks.

Or you can track the devices using sh ip arp x.x.x. and sh mac-add | i xxxx.xxxx.xxxx

rgds,

New Member

Re: finding switch port

unfortunately i dont have cisco works.

can you recommend me some freeware? and easy software? like this would be used by my support team and they dont know any thing about cisco stuff.

and i dont want to use those commands, it takes alot of pain finding PC after every hour or so.

Bronze

Re: finding switch port

You could try Nagios. I think it might do what you are looking for.

Re: finding switch port

Can we configure Nagios on a window pc?

Bronze

Re: finding switch port

Here is an example of looking:

CS1#sh ip arp 10.64.4.30

Protocol Address Age (min) Hardware Addr Type Interface

Internet 10.64.4.30 1 0006.5b1a.56a5 ARPA Vlan4

CS1#sh mac-add | i 0006.5b1a.56a5

4 0006.5b1a.56a5 DYNAMIC Po1

The output above shows me that the mac add comes from an uplink switch. I then go to the other switch

CS2#sh mac-add | i 0006.5b1a.56a5

4 0006.5b1a.56a5 DYNAMIC Fa0/17

The server is on port fa0/17.

rgds,

Gold

Re: finding switch port

what type of switches ?

if you have 3750 switches and use cdp between them, you can use the traceroute feature on the ip and mac address in the switch cli.

that will immediatly give you the switch and port the computer is installed in.

New Member

Re: finding switch port

Hi Ahmad,

If you are using Cisco Works you can use the "user tracking feature", very useful. Another option is Solarwinds switchport mapper, both of course cost $. The most likely solution in this case for your support team would probably be to use Cisco Works and assign your support team a login account.

HTH,

Brandon

625
Views
0
Helpful
7
Replies