firewall conduit command

[carl_townshend]

Hi all, can anyone tell me what the conduit command does on a pix firewall ?

[icabrera]

Hi Carl, this command was used in earlier versions instead access lists, you can use now both but normally it is used an access list.

See next url about this:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009402f.shtml

pls, rate the post if helpful

[carl_townshend]

so we wouldnt use this anymore then ?

[icabrera]

Hi, as you can see at the document you can use it if you want, it hasn't dissapear fo compatibility, but if you're going to start a new configuration if better starting using access list.

Regards.