Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Firewall (fwsm) in catalyst 6500

Hello,

I've a question, about a policy-map, class-map and other policy command!

In catalyst 6500 switch with firewall module i can't configure policy the command that I wrote above are only in switch IOS but when I make a session to fwsm there are non of them :( just like the fwsm IOS doesn't supprt them! In cisco guide about fwsm (3.1) this command are also present on fwsm not only switch IOS. What is the cause of this? what I done wrong or what I didn't do but I should??

thx for any advice!

2 REPLIES
Bronze

Re: Firewall (fwsm) in catalyst 6500

TCP connection has two Initial Sequence Numbers (ISNs): one generated by the client and one generated by the server. The FWSM randomizes the ISN.Refer URL

http://www.cisco.com/en/US/products/hw/switches/ps708/products_module_configuration_guide_chapter09186a0080577c66.html

New Member

Re: Firewall (fwsm) in catalyst 6500

Well the true reason of my trouble was my stupidity ;) I should bang in to my head.

I never tought to check the IOS wer. i assume it was the newest one but IT WASN'T! in my wer. there is no inspect just fixup so there isn't any command policy-map or class-map :) i already

have the guide for my wer. of IOS

Thx

139
Views
0
Helpful
2
Replies
CreatePlease login to create content