I have a stack of 4 Cisco Switch 3750 (1 x WS-C3750G-24T, 2 x WS-C3750-48P and 1 x WS-C3750V2-48PS) and I want to do an firmware upgrade of this stack. Actually, all the 4 switches are at the firmware version 12.2(50) SE1 "IPBase" and I want to upgrade them to 12.2(55)SE5 IPBase.
According to the release notes, all the switches in my stack are supported.
from your image looks like its trying to download the image twice. can u please try again and once its copied. check the flash if the new image is already there. if yes, then ignore the message because the switch was trying to download the image twice perhaps...
What happens if I delete the "old" bin file on the each of the 4 switch and upload then the new bin file to them?
Is there any risk with this action? It is the main backbone switch!
I would be very careful with things like this especially in production devices..will wait to see if any others have any ideas as why the switch is behaving liek that. if you get no help here then raise a TAC case to find out why its doing this.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.