Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

flapping link

                   dear all

how i can resolve flapping link problem

when i put terminal monitor command 

this appear each time new port connected

00:49:41: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet4/0/7, changed state to down

00:49:45: %LINK-3-UPDOWN: Interface FastEthernet4/0/7, changed state to down

00:49:47: %LINK-3-UPDOWN: Interface FastEthernet4/0/7, changed state to up

00:49:48: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet4/0/7, changed state to up

is that normal

if not

how i can resolve it

Everyone's tags (2)
2 REPLIES
New Member

flapping link

hi,

what device are you using?

can you do

- show interface FastEthernet4/0/7

- show run interface FastEthernet4/0/7

and post the result here?

regards,

New Member

flapping link

You can connect a laptop to it and see if the problem continues. If not then you have a problem either with the wiring or the end station. If it persists then check the port. While it's rare it's not impossible to have a hardware issue with the port.

414
Views
0
Helpful
2
Replies
CreatePlease to create content